Re: Storme's DelSol ESI project
Posted: Wed Nov 25, 2020 1:59 amPage 2 of 2
Posted: Wed Nov 25, 2020 1:59 amRe: Storme's DelSol ESI project
Posted: Wed Nov 25, 2020 2:02 amRe: Storme's DelSol ESI project
Posted: Wed Nov 25, 2020 2:09 amThere's a few little bits to clean up, and then we'll have the car back to rebush!
Re: Storme's DelSol ESI project
Posted: Wed Nov 25, 2020 7:57 pmRe: Storme's DelSol ESI project
Posted: Wed Nov 25, 2020 7:58 pmRe: Storme's DelSol ESI project
Posted: Wed Nov 25, 2020 9:49 pmProving they are never too far gone to save. Great work. Keep it up
Re: Storme's DelSol ESI project
Posted: Mon Dec 07, 2020 10:16 pmToday's job is drain holes! No point getting your rust sorted if your going to ignore these
Re: Storme's DelSol ESI project
Posted: Mon Dec 07, 2020 10:17 pmAnd the other side 
Re: Storme's DelSol ESI project
Posted: Mon Dec 07, 2020 10:31 pmManaged to not break any clips removing the windscreen scuttle! The secret is a bit of WD-40, quite a lot of patience!
Re: Storme's DelSol ESI project
Posted: Mon Dec 07, 2020 10:47 pmThere's a few places mud and leaves like to collect behind the wings!
Re: Storme's DelSol ESI project
Posted: Tue Dec 08, 2020 2:07 pmWe did briefly have some beautiful genuine rays wheels for the car...
But they turned out to be around the 28 - 32 offset mark... We were told they'd be ET40!
Some more of exactly the same wheel are on they're way from Japan as we speak, hopefully in a comfortable ET43
The wheel is a RAYS GR-N an older cast version of the CE28n... This does mean we sacrifice a bit on weight, but the brake clearance is a pretty mega 324mm ish ID at the narrowest part.