Also had a bit of cutting and sticking blue peter day with my centre console
Ive got some thin guage ally that i want to mount all my electronics in so thought id mock it all up before i start cutting. Its going to hold my boost controller, turbo timer, Apexi RSM, Link knock link, AFR, oil pressure and oil temp guages.
A few of the goodies i icked up whilst i was away (probably a bit premature considering ive not sorted the shell yet but ahh well haha)
Blox 68mm throttle body that im going to port match to my skunk2 inlet manifold.
Apexi power intake that im going to build into an alloy airbox vented through a fibreglass bonnet when i get the engine bay layout sorted.
Fibreworks fibreglass wings. As ive said before i dont think these are lighter, if anything they are peobably that bit heavier but i think the fact they rent going to rust or bend if i lean over the engine bay makes them worth every penny
Golden eagle bumper diffuser that i intend to fit to an Si or SiR rear bumper when i get hold of one. Looks pretty and will stop the rear bumper parachuting. Also i icked up a windscreen washer relocation kit from a kit car supplier, ive not decided where to put it yet but it was a bargin so i bagged it.
My Border carbon fibre seat i had in my Sol but its so pretty i had to take a pic or two. This thing only weighs 4.5kg including the side mounts and is actually really comfortable.